Welcome to Tech Talk, where our resident BMW tech Nick Owen answers all your pressing BMW technical questions, frustrations, and issues. Have a question for Nick? Email him at techtalk@roundel.org. Let’s get into it.
M240i A/C Hot Flashes
Your diagnosis matches my experience. Yes, there’s a lot of water coming out, and now I understand why it is happening. There is only one item that you did not address and that is perhaps the most puzzling, at least to me:
… the system gradually starts losing air volume while both the fan and compressor gradually increase in speed, and at the end, there is no air flow …
If you press the max A/C button you get maximum fan, maximum compressor, and maximum air flow. When the A/C fails due to high outside temperature you eventually get maximum fan, maximum compressor, and no air flow. What could be blocking the air flow?
I meant to provide you feedback on the twitchy driving issue, my apologies I never did. I took a copy of your response to the dealer and asked for an alignment, they kept the paper, did not give me a copy of the pre and/or post machine output, but the car now drives really good, so you were right on the spot, and I’m happy.
Ivan
If you press the MAX A/C button you get maximum fan, maximum compressor, and maximum air flow. When the A/C fails due to high outside temperature you eventually get maximum fan, maximum compressor, and 0 air flow. What could be blocking the air flow?
This is an example of the A/C evaporator freezing so the IHKA module turns down the interior fan and/or closes the vent doors. Tough to say exactly without seeing it. but this is probably what’s going on. Engine fan and compressor are still working because their job is just to produce cool A/C, but the module for the interior bits is controlled by a different ECU and ECU logic.
Side note: there was a bulletin on the early F30s to move the evaporator temp sensor because it was causing erroneous readings and making the A/C stop working. Might be something to just check…
Part: 64119321034 Actuator, “the only one accessible by hand without having to remove the dashboard,” I have no idea if true, but now I have lots of cold air from all vents; interestingly, they say that based on the pressures, there was a full freon charge in the system. So, you got this one right.
Ivan
Regarding M240i A/C Hot Flashes
Regarding your recent advice to Mr. Lozada‘s A/C issues in his F22. It appears SIB 64 03 13 applies. I have a similar issue on my F22 (2016 228i) that I hope will be resolved in the coming weeks by the steps outlined in the above SIB.
Brian


















